Products

Rectangle Fire Pit Burner Kit

Connect the gas transfer hose to the propane air mixer Apply tape to the external thread at the bottom of the air mixer valve and connect it to the gas transfer hose according to the options below. Connect the gas supply hose before placing the burner tray on the table top, as it will be easier to access before installation.

Send Inquiry

Fast Delievery
Quality Assurance
24/7 Customer Service

Product Introduction

There are two common feeds for propane: High PRESSURE ADJUSTABLE REGULATOR (0-20 psi): Using a HIGH pressure ADJUSTABLE REGULATOR is the SIMPLEST installation option and the lowest cost. Just note that most high pressure adjustable regulators have a 3/8 "flare fitting; However, air mixing valves (and burners) have 1/2 "NPT connectors. This high pressure adjustable regulator includes a 1/2 "NPT adapter, so it will fit into the fire pit without having to purchase any adapters.

To enable this connection, connect the 3/8 "MALE flare from a 1/2" FEMALE NPT adapter to THE male thread on the air mixer. Then connect the hose to the trumpet adapter. Tape is not required for the external threads of the flared adaptor because the flared fitting on the gas hose has a rubber washer inside for sealing.

LP Burner Connection Kit with Chrome key Valve and Regulator: Using an LP Burner connection kit with chrome key valve is a good option for a more complete look. However, installing the critical valve is a little more work because you need to drill a hole in your fire pit to install the critical valve through. This option is also more expensive than a high-voltage adjustable regulator.

To make this connection thread the gas line to the air mixing valve. The connection should be tightened with a wrench (make sure not to over-tighten - it only needs a tight fit).